Make sure it has enough power during the programming procedure.īaofeng UV-5R Chirp Software Programming Processġ) Open the CHIRP software (Latest Version), click 'Download From Radio' under 'Radio'Ģ) Select the corresponding cable driver port, and select Model 'UV-5RX' under Vendor 'Baofeng', then click 'OK' to read the radio.ģ) And you will come to the page of Memories, in which you can adjust the limited parameters (Channel, TX Frequency, RX Frequency, CTCSS/DCS, High/Low Power, and Wide/Narrow Band, etc).Ĥ) Then if you switch to the page of Settings, you can adjust the limited parameters (VOX Function, Squelch, Backlit, DTMF, FM Radio, Voice Prompt, Scanning, VFO Mode, etc).ĥ) All the modification will be saved by clicking 'Upload To Radio' under 'Radio'. Connect your Walkie Talkie with Computerġ) USB programming cable connects with the computer end.Ģ) Connect the other end of the cable with your walkie talkie.ģ) When both ends have been connected, turn on your radio. You can just plug in and use directly.ġ) Turn on the computer, check if your computer system meets the requirements.Ģ) Download the manufacture programming software on .uk or CHIRP programming software.Ĥ. If you use an FTDI cable, it does not need to be installed with a driver. USB programming cable - The driver should be installed before programming.ġ) Find the corresponding driver of the system.Ģ) Click install and wait for the installation.ī. Windows XP, Windows 7, Windows 8 and Windows 10Ī. Operating System: Windows 98, Windows Me. Since the Baofeng Radio UV-5R series share the same manufacture programming software and CHIRP support most of Baofeng UV-5R models, this programming guidance is a helpful preference to the following model：īaofeng GT-3, BF-F8/BF-F8+, BF-F9, UV-5R+/UV-5R+Plus, UV-5RA/UV-5RA+/UV-5RAX+, UV-5RAX (2M/1.25M), UV-5RE/UV-5RE Plus, etc.

How To Program Baofeng UV-5R Series With Programming Software This software is used for Baofeng V Series Radio This software is used for BF-T60 BF-988UV Radio This software is used for BF-H6 10W Radio

This software is used for UV-82 III Tri-band Radio This software is used for UV-9R, UV-9R Plus, T-57, R760 Waterproof Radio This software is used for DM-1702 GPS Tier II Radio This software is used for DM-5R Tier II Radio This software is used for UV-82, Misuta 82 Plus Radio This software is used for BF-888S, BF-888S plus,BF-R5,BF-T99 Radio This software is used for UV-5R III, F8+ III, UV-S9 Tri-band Radio This software is used for UV-5R, BF-F8+, BF-F9 Radio

Baofeng programming software Model/series

Baofeng bf 888s programming software